Friends,
Based on the RTI from one of the candidates, here is what ONGC informed in reponse of RTI.
What do you think about it?
Based on the RTI from one of the candidates, here is what ONGC informed in reponse of RTI.
What do you think about it?
TODAY'S GATE TIP
Don't attempt questions for which you are not sure. It will take your time and may lead to negative marking. Read question two times.
In MCQS, go with the most appropriate choice, don't be too much critical about choices given. Use the constraint of the question wisely like only one right option. & Remember, even if you are right you can be awarded Bonus marks in GATE, it has happened before. So don't stuck on one question if you find it little tricky and go with the best appropriate choices available
Don't attempt questions for which you are not sure. It will take your time and may lead to negative marking. Read question two times.
In MCQS, go with the most appropriate choice, don't be too much critical about choices given. Use the constraint of the question wisely like only one right option. & Remember, even if you are right you can be awarded Bonus marks in GATE, it has happened before. So don't stuck on one question if you find it little tricky and go with the best appropriate choices available
LWD/MWD are often used to measure real-time data.
Which of the following is specially measured by LWD but not by MWD?
Which of the following is specially measured by LWD but not by MWD?
Anonymous Quiz
15%
Drilling orientation
14%
Well geometry
54%
Porosity
17%
Azimuth
Statement I: All gases are miscible with crude oil except methane.
Statement II: CO2 is miscible with oil only above minimum miscibility pressure.
a. Only I is correct
b. Only II is correct
c. I & II are correct
d. I & II are incorrect
Statement II: CO2 is miscible with oil only above minimum miscibility pressure.
a. Only I is correct
b. Only II is correct
c. I & II are correct
d. I & II are incorrect
A gaseous hydrocarbon-bearing zone can be best identified by a combined analysis of
Anonymous Quiz
13%
a. Density and Self potential (SP) log
60%
b. Density and Neutron log
11%
c. Sonic and Neutron log
16%
d. Natural Gamma ray (GR) and Neutron log
Best packer suitable for shallow depth and low pressure reservoirs
Anonymous Quiz
23%
Tension set packer
24%
compression set packer
30%
Hydraullic packer
23%
Weight set packer
Detonation:RDX :: Deflagaration:______
Anonymous Quiz
27%
TNT
20%
HMX
32%
Lead Azide
22%
ammonium sulphate
Intermittent Gas lift: Pushing of static liq::: Hydraullic lift:____
Anonymous Quiz
20%
Density reduction
27%
pressure transfer
33%
piston lift
20%
Momentum transfer
Depth of gas lift valve doesnot depend on
Anonymous Quiz
26%
Gas density
25%
Liquid density
24%
Bottomhole pressure
25%
wellhead pressure
which of the following is not Rotary pump
Anonymous Quiz
29%
PCP
16%
SCREW PUMP
22%
RADIAL PUMP
32%
LOBE PUMP
Which of the following has the least influence on bit nozzle pressure drop?
Anonymous Quiz
46%
Bit Diameter
12%
Flow Rate
31%
Mud Density
11%
Nozzle Area
Which of the following is not an objectives of well testing?
Anonymous Quiz
8%
To evaluate formation permeability
44%
To evaluate the oil saturation
33%
To evaluate the hydrocarbon reserves
15%
To evaluate well damage
Which one of the following basins is producing petroleum from the coal-rich reservoir rocks?
Anonymous Quiz
16%
Rajasthan Basin
30%
Cambay Basin
21%
Cauvery Basin
33%
Krishna–Godavari Basin
One of the principles of stratigraphy that says "The study of present is the key to study the past" is________
Anonymous Quiz
22%
Law of faunal successions
34%
Principle of correlations
26%
Order of superposition
19%
Doctrine of uniformities
Method that is used to calculate the rate of heat transfer in heat exchangers when there is insufficient information to calculate the Log-Mean Temperature Difference (LMTD).
Anonymous Quiz
43%
BTU method
16%
HTU method
33%
NTU method
9%
CTU method
Baffles in the shell side of a shell and tube heat exchanger
Anonymous Quiz
27%
A.increase the cross-section of the shell side liquid.
23%
B.force the liquid to flow parallel to the bank.
45%
C.increase the shell side heat transfer co-efficient.
5%
D.decrease the shell side heat transf