⚠️ Note: If you are on iBridgeOS 10.1 or lower, do not DFU restore/update your Mac with Apple Configurator or iBridgeOS 10.2. Otherwise, you will lose untethered compatibility support. You can still perform an untethered bypass if you are on iBridgeOS 10.1 or lower. The same applies in the near future: if you get any T2 Mac for bypass, check the iBridgeOS version first, then proceed accordingly until we find an untethered solution for the latest iBridgeOS.

➖Compatible All T2 Mac Models:
💻 iMac (A2116) (Retina 5K, 27-inch, 2020)
💻 iMac (A2115) 2019;
💻 iMac Pro (A2110) 2019;
💻 Mac Pro Tower (A1991) (2019);
💻 Mac Pro (A2304) (Rack,2019);
💻 Mac Mini (A1993) (2018);
💻 MacBook Pro (13-inch, Early 2020)
💻 MacBook Pro (13-inch, 2018)
💻 MacBook Pro (15-inch, 2018)
💻 MacBook Pro (15-inch, 2019)
💻 MacBook Pro (16-inch, 2019)
💻 MacBook Pro (A1989,A1990) 2018/2019;
💻 MacBook Pro (A2159,A2141) 2019;
💻 MacBook Pro (A2251,A2289) 2020;
💻 MacBook Air (Early 2020)
💻 MacBook Air (A1932) 2018/19;
💻 MacBook Air (A2179) 2020;

💻😉🎥 Untethered iCloud Bypass iBridgeOS 10.1 and lower Full Video Guide: https://youtu.be/cyfOgtsRZm0

💻😉🎥 Tethered iCloud Bypass iBridgeOS 10.2 Full Video Guide : https://youtu.be/IB_8eKDJznc

✍🏻 How to use New Hfz T2 Premium Aio v2.1 for iBridgeOS 10.2/10.3 (Tethered Bypass)

📝 Note: "Tethered bypass" means the examples below scenarios:

➖ If you force-shutdown your Mac by holding the power button for 5 seconds or pressing it directly, it goes to lock again.
➖ If the battery runs out, it then goes to lock again.

✍🏻Tethered Bypass Steps :

➖First, put your locked Mac in DFU mode. Open the Hfz tool, select the correct model and iBridgeOS information from the tool list, then:

➖Click "Boot & Prepare" and wait for the jailbreak to complete.

➖ Now, click "Activate." You will see "success."

➖ Boot your Mac to Internet Recovery (Cmd + R //OR// Option + Cmd + R). Connect to Wi-Fi and proceed, waiting for the recovery to load.

➖ Once you reach the Language and Country selection page or Recovery assistant etc, you will encounter a freeze or get stuck (due to tethered bypass).

➖ Important: Unplug the cable and replug it. Close the Hfz tool and reopen it. Now, put the locked Mac back into DFU mode and click the "FastBoot" button. Once it's successful, wait for the Mac to boot up automatically. Otherwise, boot manually to recovery again ( By CMD+R //OR// (Option+CMD+R)) , then you can proceed.

➖ Once recovery mode appears: Go to Disk Utility > Erase SSD. Go back and install the OS.

Once the OS installation is done, the tethered bypass is completed. ✅

➖ Remember, this is a tethered bypass. You need to follow some steps and precautions to preserve the bypass. For example, do not use the power button directly to reboot or power off the Mac. Instead, use the Apple Menu option to reboot/shutdown the Mac safely. Also, make sure not to drain the battery completely; otherwise, you will have to revive the Mac again using the tool.

⚠️ Note: If you are on iBridgeOS 10.1 or lower, do not DFU restore/update your Mac with Apple Configurator or iBridgeOS 10.2. Otherwise, you will lose untethered compatibility support. You can still perform an untethered bypass if you are on iBridgeOS 10.1 or lower. The same applies in the near future: if you get any T2 Mac for bypass, check the iBridgeOS version first, then proceed accordingly until we find an untethered solution for the latest iBridgeOS. And if you are already on the latest iBridgeOS 10.2, you can use tethered Bypass, which is currently a possible solution.

💻😉🎥  T2 Master V1.1 Tethered iBridgeOS 10.2 & 10.3 ( Battery Dead Not Lock Fixed) : https://youtu.be/R-K57xSrWbM

😉🎥 Tethered iCloud Bypass iBridgeOS 10.2 Full Video Guide : https://youtu.be/IB_8eKDJznc

ℹ️ 💻 👨‍💻 Just a Tip: For those who have performed a Tethered iCloud Bypass on iBridgeOS 10.2/10.3 with the HFZ T2 Tool, follow these important instructions to safely restart and shut down your T2-bypassed Macs or to revive the stuck Mac again:

⚙️ How to safely reboot/shutdown mac in tethered Bypass? :

✍🏻 Solution: Important In tethered Bypass do not use power button or off directly. Instead, use the "Restart" or "Shutdown" option from the Apple menu to safely shutdown/reboot or use sleep mode option to safely off it. ✅

📝 Note: "Tethered bypass" means the examples below scenarios:

➖ If you force-shutdown your Mac by holding the power button for 5 seconds or pressing it directly, it goes to lock again.
➖ If the battery runs out, it then goes to lock again.

⚙️ How to revive the mac again in tethered Bypass with data save state ? :

✍🏻 Solution: To Revive the mac in tethered Bypass: in case you got locked/stuck by mistake in tethered bypass if you used the power button by mistake or the battery goes off with above two scenarios and you need to revive it from that point then:

First Enter DFU mode and Click the "Fastboot [USE AFTER TETHERED] Button" Option from Hfz T2 Tool, This will allow the device to turn on normally again without data loss and it will come to the same point where you left off last time, there’s no need to repeat the whole bypass process again. ✅

➖ Of course, if you completely wiped, erased, reset, or restored the Mac, then yes, in that case, you would have to rebypass and redo the complete bypass process again from scratch to open the Mac.

💻😉🎥  T2 Master V1.1 Tethered iBridgeOS 10.2 & 10.3 ( Battery Dead Not Lock Fixed) : https://youtu.be/R-K57xSrWbM

😉🎥 Tethered iCloud Bypass iBridgeOS 10.2 Full Video Guide : https://youtu.be/IB_8eKDJznc

💻😉🎥  T2 Master V1.1 Tethered iBridgeOS 10.2 & 10.3 ( Battery Dead Not Lock Fixed) : https://youtu.be/R-K57xSrWbM

💻😉🎥 Untethered iCloud Bypass iBridgeOS 10.1 and lower Full Video Guide: https://youtu.be/cyfOgtsRZm0

💻😉🎥 Tethered iCloud Bypass T2 AIO Premium V2.1 iBridgeOS 10.2/10.3 Full Video Guide : https://youtu.be/IB_8eKDJznc

💻😉🎥  T2 Master V1.1 Tethered iBridgeOS 10.2 & 10.3 ( Battery Dead Not Lock Fixed) : https://youtu.be/R-K57xSrWbM

⚠️ iBridgeOS 10.3 is no longer being signed by Apple. This means that downgrading or restoring to this versions via Apple Configurator is no longer possible , Version is unsigned now.

🛑 iCloud Bypass currently not supported Latest iBridgeOS 10.4

🚧 Let’s wait for the T2 Tools to release a fix for the recent Apple Patch affecting the T2 iCloud Bypass Service, for the new iBridgeOS version 10.4 & MacOS Tahoe 26.4/Sequoia 15.7.5/Sonoma 14.8.5 In the meantime, try to stay on the lowest version possible if you are already done with the iCloud Bypass on T2 Macs, and if you are going to bypass, then avoid restoring your Mac with Apple Configurator, as it will result in an update to iBridgeOS 10.4, which is not supported for the bypass at the moment.

❌ For already bypassed Macs, don't use OTA updates from settings, as it will directly update to Tahoe 26.4/Sequoia 15.7.5/Sonoma 14.8.5 which is not supported for bypass at the moment. For safe use, use OTA blockers to avoid mistakes or turn off Automatic Updates & Security Updates from the settings.

✅ Bypass Safe in iBridgeOS 10.3 & lower macOS Tahoe 26.3.2/Sequoia 15.7.4/Sonoma 14.8.4 and Ventura/Big Sur/Monterey/Catalina/Mojave/High Sierra.

💻👨‍💻 Untethered iCloud Bypass is still available till iBridgeOS 10.1 and lower & 10.2/10.3 Tethered Bypass.

Now, let's wait and see for future updates. I will keep you posted if any more information comes.

💻😉🎥  T2 Master V1.1 Tethered iBridgeOS 10.2 & 10.3 ( Battery Dead Not Lock Fixed) : https://youtu.be/R-K57xSrWbM

💻😉🎥 Untethered iCloud Bypass iBridgeOS 10.1 and lower Full Video Guide: https://youtu.be/cyfOgtsRZm0

💻😉🎥 Tethered iCloud Bypass T2 AIO Premium V2.1 iBridgeOS 10.2/ Full Video Guide : https://youtu.be/IB_8eKDJznc

How to use ?

- Restore device with latest firmware (recommended)
- Register device via serial number
- Activate the device with tool without connecting to Wi-Fi
    ~ done ✅