337.The expansion of Portland Pozzolana cement should not be more than ____ mm.

338.According to IS: 303 – 1989, the thickness of plywood boards (in mm units) in a 3-ply board is

339.For getting good brick bonds, the amount of lap should be minimum ____ along the length of the wall.

340.The grooves provided at the end of corbels, lintels, etc. for discharging rainwater clear of walls is called

341. An alidade is used in plane table surveying for

342. Which one of the following is not an instrument for setting out right angles?

343. In permanent adjustment of levels, two peg test is done to correct or adjust:

344.In plane table, the operation which must be carried out is:

345.Which of the following methods results in higher accuracy of measuring horizontal distance on rough grounds?

346. In Tacheometric surveying, the Subtense bar method is also called the

347.Which of the following strengths is most important for pavement concrete?

348. The end supports of a bridge superstructure are known as

349.The drainage layer in the highway pavement is known as

350. When a cantilever beam, is loaded at its free end, the maximum compressive stress shall develop at:

351.What type of structural element is typically used to provide fixed support at the ends of a fixed beam?

352. In singly reinforced beams, steel reinforcement is provided in

353.The probability distribution taken to represent completion time of a PERT network analysis is